Knowledge base · Water
Cloudy or foaming spa water
Cloudy water in a hot tub almost always has one of four causes: a full filter, a pH that is off, too much bather load, or water that is simply spent after months of use. Foam and a chlorine smell each have their own story. Below, per complaint: the cause, what you do in which order, and when only a refill still helps.
Loading photoThe answer
Why your spa water is cloudy, and why more chlorine is rarely the fix
Four causes, in the order we meet them in practice.
Cloudy water is not a chlorine shortage but a signal. The filter is letting dirt through, the pH is wrong so chlorine cannot work, there is more skin oil and soap in the water than it can carry, or after months the water is full and holds nothing any more.
Whoever responds to cloudy water with an extra scoop of chlorine skips the first three causes. Chlorine only works properly when the pH is right. The American CDC (2024) gives 7.0 to 7.8 for hot tubs, and in our service work we use the narrower band of 7.2 to 7.6. If the pH is too high, the chlorine does little and the next day you measure a low reading again.
That is why the order matters more than the product: first the filter, then measure, then adjust, and only then chlorine. A quarter of an hour of work, and you are not pouring in one product after another for a week.
Per complaint
Four complaints, four causes
Cloudiness, foam, smell and vanishing chlorine each ask for something different.
Look and smell before you add anything.
Cloudy
Milky or dull water
Usually the filter: full, worn or not rinsed for too long. Then the water balance: at a pH above 7.6 chlorine works poorly and fine particles stay suspended. After months the water fills up with everything you have dosed into it. Then only fresh water helps.
Foam
A layer of bubbles that stays
Foam comes from soap: traces of body lotion, deodorant, shampoo and the detergent in swimwear. Every time the jets come on, it gets whipped up. An anti-foam product removes it, but not the cause. Showering before the bath and rinsing swimwear without detergent make more difference than a bottle.
Smell
A sharp chlorine smell or a musty one
If you smell chlorine, you are almost certainly smelling chloramines: combined chlorine that forms when chlorine reacts with sweat, skin cells and cosmetics (CDC, 2025). It is a sign of too little working chlorine, not too much. A musty or drain-like smell points more to biofilm in the pipework, and dosing into the tub does not reach that.
Chlorine gone
Back to zero every day
A hot tub is small, warm and moves a lot. Those three together mean it uses up its sanitiser faster than a swimming pool (CDC, 2025). Sunlight and the mist from the jets break chlorine down too. If you measure right after a session, a low reading is normal. If it stays low after a day of rest, there is too much load or biofilm in the water.
In this order
What actually helps, from filter to chlorine
Five steps, one at a time. Let a filter cycle pass before you do the next.
Do not do everything at once. Each step changes the reading of the next, and whoever doses three products in one evening does not know the next day what worked.
- Take the filter out and rinse it. Grease and sunscreen do not rinse off. Leave the filter overnight in a cleaning solution. If the cartridge is flattened or discoloured, replace it. This alone clears a large share of cloudy tubs.
- Measure, and adjust in the right order. First the alkalinity to 80 to 120 ppm, because that keeps the pH stable. Then the pH to 7.2 to 7.6. Only then the free chlorine. The CDC (2024) advises at least 3 ppm free chlorine for hot tubs. With AquaFinesse, 1.5 to 3 ppm is enough; that is the level AquaFinesse itself specifies. If you smell chlorine or the water turns cloudy, always go to 3 ppm. Adjusting the other way round means doing the work twice.
- Take the load away. Shower without soap before the bath, swimwear without detergent, no lotion just before bathing. It sounds small and makes more difference than any product.
- For smell: a temporarily higher chlorine dose. Chloramines break down when free chlorine is briefly high enough. For public pools the CDC (2025) uses ten times the measured combined chlorine. Do this with the cover open and wait until the reading is back below 5 ppm before you get in.
- Let the pump do its work. After adjusting, the filter needs a few cycles. Water that was dull in the evening is often clear the next morning without you doing anything more.
Refilling
When fresh water is the only solution
And what you do differently after filling than last time.
Everything you dose leaves something behind, and sweat and cosmetics dissolve into substances the filter does not catch. After months the water is full: it no longer holds chlorine, goes dull again after every session and barely responds to adjusting. That is the moment to drain, a few times a year, depending on how intensively you use the spa.
Stubborn foam that returns after cleaning the filter and showering, and a musty smell that lingers after a chlorine shock, are also signs the water is spent. Adjusting then costs more product than refilling.
After the refill
Clean the pipework before draining, not after. Biofilm does not sit in the tub but in the hoses behind it. Whoever drains first and then fills carries it into the new water. So run a pipe cleaner through the old water first. Between two refills, AquaFinesse, which we supply, works on that same biofilm.
Measure the tap water before you add anything and write the values down. Then alkalinity, pH, chlorine, in that order, and a clean or new filter. Whoever keeps the starting values sees immediately what has changed at the next complaint.
Points to consider
Chlorine-free is not maintenance-free
Measuring takes a few minutes a week. Whoever does not want that chooses a package.
We do not supply salt electrolysis or products with chlorine-free on the label. Warm water with people in it needs sanitising, and sanitising needs a pH that is right. Even with AquaFinesse, which lowers the amount of chlorine needed, you keep measuring. You just dose less. If you would rather hand that over, we supply an automatic measuring and dosing system, the Hanna Security Pool Plus. It measures pH and redox, a measure of how well the chlorine is working, and doses automatically. Check the values now and then with your own meters: the electrode needs regular calibration.
In the Netherlands there is no legal water standard for a hot tub at home. The rules for bathing establishments apply to public pools, so at home you are the operator yourself. In practice: a few minutes a week with a test strip, and a filter you rinse. Whoever does not want to keep that up lets us do it with a Wellness package.
How we do it
Water readings in your maintenance record
Registered at installation, the same engineer, also for a spa you bought elsewhere.
At installation we record every unit: serial number, water reading and a photo of the foundation. That first water reading goes into your water file, together with what we measure and adjust at every visit. If you call later about cloudy water, that file is at hand: what is installed at your home and what the water did last time.
The person who installed your spa also comes for a water problem. No changing engineers, no call centre. A spa you bought elsewhere we take into maintenance just the same. We start with a water reading.
Whoever prefers to hand over the measuring chooses a Wellness package: Select at € 32.50 a month with one service visit and one filter set a year, Prime at € 59.95 with two visits and an annual UV lamp replacement, Elite at € 99.95 with a filter set at every visit and labour for faults included. The first visit costs € 365 once, and you cancel per year. Major replacements, such as a complete pump, fall outside the package even with Elite.
Further reading
Related articles
Spa water calculator
Enter your measured pH, alkalinity and chlorine and see how many grams of which product to add.
Maintenance and service
The three Wellness packages side by side, the single annual service and how we resolve a fault.
A fault in your spa: what to expect from after-sales
What happens when something really breaks, and who comes.
Frequently asked questions on maintenance and water
How often to refill, whether it works without chlorine and what you do yourself between two visits.
Sources
Sources and author
The guide values come from the CDC and the PHTA. The practical order from our own service work.
Personal advice
Cloudy water? Give us a call.
We answer the phone personally. If you have a file with us, it is at hand. If not, we start with a water reading.

