085 070 41 71CallPlan your visit

Knowledge base · Energy

Heating a hot tub with a heat pump

Heating a hot tub with a heat pump is possible, and it saves electricity. The heat pump draws heat from the outside air and turns one kWh of electricity into roughly three to five kWh of heat. A dynamic energy contract then mainly changes when you heat, not how much heat your spa needs.

Steam rising from the warm water of a spa in a winter gardenLoading photo

The answer

How a heat pump heats a spa

A heating element makes heat; a heat pump moves it.

A heating element converts every kWh of electricity into exactly one kWh of heat. A heat pump does something different: it extracts heat from the outside air and passes it to the spa water through a heat exchanger. Moving that heat takes electricity, but far less than making the same heat from scratch.

Milieu Centraal (2026) uses the general guideline that a heat pump turns one kilowatt-hour of electricity into three to five kilowatt-hours of heat. That figure was written for homes, not specifically for spas, but the mechanism is the same. For a spa that is kept at temperature day and night, this is, after insulation and the cover, the biggest lever you have on your electricity use.

What a heat pump does not do is reduce heat loss. How much heat your spa loses per day is set by the insulation of the shell, the cover and the difference with the outside air. The heat pump makes topping up that loss cheaper. How the loss itself works is explained in our article on electricity use.

How it works on a spa

Four things that decide the efficiency

Outside air, outside temperature, defrosting and the spot where it stands.

The efficiency of a heat pump is not a fixed number. It moves with the weather and with where the unit is placed.

Source

The outside air is the heat source

Even air at five degrees contains heat. The fan draws that air across an evaporator, the refrigerant absorbs the heat, the compressor raises its temperature and a heat exchanger passes it to the water flowing through the unit. The spa pumps water past the heat pump for this. The unit sits in the pipework, not loose beside it.

Outside temperature

Warmer outside, better efficiency

The warmer the air, the easier the heat is to extract. In spring and autumn a heat pump runs at its best. Below zero it gets harder: the Consumentenbond (2026) explains that extracting heat from air colder than zero degrees becomes more difficult, and that efficiency then drops. It still works, only less favourably.

Defrosting

Frost on the evaporator

In damp, cold weather, frost settles on the evaporator. The heat pump defrosts it by itself, with short pauses in which it delivers no heat for a moment. That is why the Consumentenbond counts those defrost cycles and the consumption of the heating element in its heat pump test (2025). For a spa it means that on the coldest days the heating element steps in. It is still there for a reason.

Placement

Air all round and an ear for the neighbours

Keep the air intake and outlet clear and avoid drawing cold exhaust air back in. Ask the installer to assess noise at neighbouring properties. The Dutch Bbl specifies 40 dB for outdoor units at adjoining homes. The applicable measurement method and rules must be established for each situation.

Dynamic tariff

What a dynamic contract does change, and what it does not

It makes hours cheaper. It does not make your heat loss smaller.

With a dynamic energy contract your electricity price follows the wholesale market. That suits a spa, because warm water is a buffer: you choose when to buy the heat.

How does a dynamic tariff work?

Your electricity rate is then linked directly to the spot market, the exchange where electricity is traded a day ahead (ACM, 2021). The price changes per hour or per quarter of an hour, depending on your contract (ACM ConsuWijzer). You know those prices a day in advance through your supplier’s app or website, and you need a smart meter for it (Consumentenbond, 2026). When there is plenty of sun or wind, electricity is often cheap. In the busy evening hours it is dearer.

What changes about the moment of heating?

Everything that can be shifted. Water holds heat for a long time, so you can let the spa warm an extra degree in a cheap hour and let it rest in an expensive one. A heat pump with a time schedule, or a smart switch that responds to the day-ahead prices, does that for you. If you have solar panels, the afternoon is doubly interesting: the Dutch net-metering scheme (salderingsregeling) ends on 1 January 2027 (Rijksoverheid), and electricity you use yourself is then worth more than electricity you feed back.

What does not change?

The heat loss. A spa that is kept at temperature day and night loses that heat in the expensive hours too, and the heating tops it up as soon as the water drops. A dynamic tariff makes kilowatt-hours cheaper. It does not make them fewer. Insulation and the cover remain the first step, the heat pump the second. The tariff comes after that.

Is there a risk?

Yes. Prices can rise sharply, for instance in a hard winter (Consumentenbond, 2026), and that is exactly when your spa asks the most. The ACM points out that with such a contract the bill is higher in winter than in summer. Those who can carry that and let the spa switch smartly come out ahead. Those who prefer a fixed amount per month are better off with a fixed contract. That choice sits with you and your supplier, not with us.

Points to consider

Where the heat pump does not help

What we say before it becomes a line on the quotation.

With us a heat pump is a line on the quotation, not a standard fitting. That is deliberate: it has to suit your spa, your garden and the way you use the spa.

  1. It costs money to buy. A heating element is in every spa. A heat pump comes on top. Whether that pays depends on how many months a year the spa is kept at temperature. Those who bathe all year get the most out of it, and the more water has to be kept at temperature, from a small spa to a swim spa, the more the heat pump weighs in the sum. We work it through with you at your own electricity rate, without promising a payback period.
  2. It needs space and makes noise. The unit wants free air and a spot where the fan does not bother your terrace, or the neighbours’ terrace. In a small, walled town garden that is sometimes harder than in an open garden. That is why, at the consultation, we first look at where it could stand, and only then at whether it makes sense.
  3. In frost the element helps out. On the coldest days a heat pump delivers less and defrosts more often. Then the heating element steps in. That is not a flaw but the intention: the heat pump does the work for most of the year, the element catches the extremes.
  4. It is no miracle cure for a poor cover. A warped or waterlogged cover lets heat escape that the heat pump then has to replace. Replace the cover first, then the heating. Otherwise you pay for technology that is busy compensating for a leak.

In practice

How we approach it

A separate line on the quotation, a spot that fits and a file that stays.

With our spas the heat pump is a separate line on the quotation, with the price next to it. You see exactly what it costs and strike it out if it does not pay for the way you use the spa. We would rather have that conversation beforehand than afterwards.

It does not always have to be a new spa either. For one client we fitted a heat pump to a swim spa. Tim S wrote about it on Google. Whether that is possible on another spa differs per model and per set-up.

We register every installation: serial number, water reading, photo of the base. If there is a heat pump, it goes in the same file. If you call later with a question about consumption, we have that file to hand and you get us on the line.

Further reading

Related articles

Further reading

What does a spa cost in electricity?

Where the electricity goes, the six levers that decide consumption and the sum with your own rate.

Further reading

Installing a hot tub: power, base and the crane

What has to be arranged before installation, from the meter cupboard to the ground it stands on.

Further reading

Maintenance and service

Three plans, no call-out charge for a fault, and maintenance for spas bought elsewhere too.

Sources

Sources and author

Every external figure has a name and a year. What concerns us comes from our own way of working.

Written by

Max van Tricht

Co-owner Sunspa ’t Gooi · technical and service

Max handles the technical side: he installs, registers every installation and keeps a water file for each client. If a fault comes up, the person who arrives already knows your spa.

IPLO: rules for installation noise

Sources

Efficiency: Milieu Centraal (2026). Noise rules: IPLO (2026). Efficiency in cold and defrosting: Consumentenbond (2026 and 2025). Dynamic contract: ACM (2021), ACM ConsuWijzer and Consumentenbond (2026). Net metering: Rijksoverheid, act passed 17 December 2024.

Author

Max van Tricht, Sunspa ’t Gooi, based on installations and consultations from ’s-Graveland.

Last updated

29 September 2026

Personal advice

The sum for your spa and your tariff

We use your electricity rate and usage to discuss whether a heat pump makes sense for your spa. Call us or visit the showroom.

WhatsApp